FAQs

What to know We strongly recommend to perform firmware upgrade only when this is required, please if you have any doubt contact immedialtely Exor International technical support department at ...

What to know Designer 6.10, when executed under Windows 7 or Windows 10, may show "Arial/CourierNew Font need to be installed in this system" warning dialog when the software is launched (see below ...

What to know In case of type 58 panels (for example eTOP40) 32Mb memory cards are supported starting from firmware version 5.12M.

What to know The firmware downgrade operation of a panel consists in the installation of a firmware version that is older than the firmware version installed on the operator panel at production time ...

What to know The UniOP Designer operator panels family support the connection with Siemens S5 plc family, using the SimaticS5 communication protocol.

What to know We strongly recommend to perform firmware upgrade only when this is required, please if you have any doubt contact immediately Exor International technical support department at ...

What to know The operator panel Firmware components can be upgraded from Designer trough a Serial or Ethernet connection.

What to know The eTOPxxC series, eTOP300 series and eTOP04C operator panels have an integrated USB port that can be used to programmer the device trough an USB flash drive.

What to know The Double Protocol feature requires proper support both in Hardware and Firmware.